Video Input Module For BMW E87 1 Series
Nav Video Installation Guide:
1. Before working, please make sure the entire system power is off (after pulling out the key, only the
monitor is off, and the rest of the system is off approximately 5 minutes later.)
2. Turning on the car with the monitor and the connecter removed may causes an error code. Do not
turn on the vehicle until the work is done.
3. Please use appropriate tools for the job.
4. Do not use excessive force in assembling, disassembling, tightening or pulling.
5. Be careful with sharp objects around the working area, use tape and cloth to prevent scratches.
6. The power cable has a fuse block; do not bypass it when installing the module.
LCD IN and OUT
The NV_BMW356 unit is installed inline of the BMW OEM LVDS connector. The factory BMW LVDS connector that is plugged into the back of the BMW LCD Screen will connect to the port labeled “LCD IN” on the NAV VIDEO Module. Then, the LVDS cable provided with the NAV VIDEO Module will connect to the port labeled “LCD OUT”, the other end of this cable will be plugged into where the factory BMW LVDS connector was once plugged into, at the back of the LCD Screen. Note for BMW 1 SERIES and Mini Cooper – You will need to remove/trim the key-pin on the outside of the LVDS connectors on both the factory cable and BMW356 cable.
AV1 / AV2 / AV3
Composite Video & Audio input for any video device (only video will go into the OEM navigation / multimedia system, audio is only for output switching.)
AV OUT
Will output the audio and video from AV1, AV2 or AV3 source, depending on which is currently selected.
REAR-C/R-CAM
This composite video connector will accommodate a rear video camera that features an NTSC composite output. This input is activated when the vehicle goes into reverse.
KEYPAD
Though this is normally unnecessary for standard operation of the module, it is sometimes needed for initial setup and should be left connected to the module, even if not used.
RED (ACC) WIRE
Connect this wire to an Accessory (test first!) output. Optionally, a CAN→Accessory module can be used to add a “true” accessory power source.
BLACK (GND) WIRE
Connect this wire to a solid chassis ground or the Brown wire (test first!) behind the screen.
GRAY (LAMP/REAR-C) WIRE
Reverse trigger. When 12V DC is applied to this wire, the REAR VIEW CAMERA input will automatically be displayed on the screen. This is often used for a reverse camera setup.
PURPLE (SAFE) WIRE
This wire does not get connected.
Get pdf Video Input Module For BMW E87 1 Series
Related Searches:
Comments
Leave a Reply
