EPSON Stylus Pro 4880 Quick Installation Guide

Step for inspecting Sublijet IQ Catridge for loose chips:
1. Check the product package to ensure that the chip remains attached to the cartridge itself and has not dislodged in the plastic bag.
2. Determine if the chip is securely attached by tapping the cartridge a few times on a hard surface, watching to ascertain that the jolt does not dislodge the chip.
3. Once the cartridge is removed from the bag, rub an eraser over the surface of the chip, to determine if it remains stationary within it’s mounting slot. Use of any item other than an eraser is not advised and can damage the chip.

Installing Sublijet IQ Cartridge:
If you are replacing existing cartridges because they are empty or low, please see the following instructions. If not, go directly to step #1.

When a cartridge is empty or extremely low, “INK OuT” will display on the LCD panel. Raise the ink levers on either side of the printer. The cartridge position indicator on the LCD panel will flash on and off, indicating which cartridge is low or empty. Be sure you have the correct color cartridge replacement for that position.

1. Ensure the printer power is on. Press the ink compartment cover to release the latch and open the cover.
NOTE: The LCD Panel will indicate the ink colors of the original OEM ink configuration and not the SubliJet ink configuration. (See Figure # 3 to the right.
2. Raise both ink levers. (Located @ the right side of each ink cartridge compartment.)
3. Install the ink cartridges into the colorcoded slots in the order that your system is currently using, starting from left to right.

Get pdf EPSON Stylus Pro 4880 Quick Installation Guide

Manual Under Hardware, Printer

Related Searches: , , , ,

Comments

Leave a Reply