Honda CR-V Throttle Cable Service Bulletin
Contamination on the throttle drum can cause the throttle cable to move with the cruise control cable. If this happens when you cancel the cruise control function, the throttle cable can jump its track on the throttle drum, resulting in no throttle response.
CUSTOMER NOTIFICATION
All owners of affected vehicles will be sent a notification of this product update. An example of the customer notification is at the end of this service bulletin. Not all vehicles within the VIN range are affected by this product update. Before beginning work on a vehicle, verify its eligibility by checking at least one of these items:
• The customer has a notification letter.
• The vehicle is shown on your campaign responsibility report.
• The vehicle is shown as eligible on an i N VIN status inquiry.
If any affected vehicles are in your new or used vehicle inventory, repair them as described in this service bulletin.
Read more
2006 Honda CR-V EX Front Door Panel Removal/Installation
Special Tools Required
Trim pad remover, Snap-on A 177A or equivalent, commercially available
KTC trim tool set SOJATP2014
NOTE: Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
1. Using a trim tool, pry out the upper portion of the cover (A) to release the hooks (B), then remove the cover.
2. Remove the screws.
3. Driver’s door: Pull the inner handle (A) rearward and out half-way to release the power door lock switch bracket (B) from the door panel (C).
Read more
1997-2001 Honda CRV Adjustable Coilover Kit
This coilover kit is designed to allow both race-ride and street-ride heights. It is not recommended to run race-ride height for normal street driving. This will result in more tire wear due to the excessive negative camber, which creates more stress on the wheel hubs and ball joints. With the vehicle jacked up and secured on jack stands, raise (clockwise) or lower (counter clockwise) the aluminum perches with the supplied spanner wrenches to the desired height. Depending on which way turned, securely tighten the other perch against it. Lower the vehicle to check ride height. This processed may need to be repeated until the desired ride height is achieved. Camber and toe settings will change depending on the height adjustments. A wheel alignment is recommended after complete installation.
Read more
2003 Honda CR-V Trailer Hitch Installation
1. Make sure you have the anti-theft codes for the audio and navigation systems (if equipped), and write down the XM radio presets (if equipped).
2. Disconnect the negative cable from the battery.
3. Fold the rear seat forward.
4. Remove the rear door sill trim (three clips)
5. Remove the cargo area floor (two hooks).
6. Remove the two cargo tie-down hooks (two vehicle bolts).
Read more
Honda Civic/CRX/del Sol Fuel Pressure Gauge Set Installation Instructions
The B&M Fuel Pressure Gauge Set requires the user to assemble the gauge to the banjo bolt (and 90° fitting depending on application). Since the gauge and fitting are connected with a 1/8″ NPT (National Pipe Thread), please use a pipe sealer such as Teflon® to avoid possible fuel leaks. The connection between the fitting and the fuel line requires no sealer since they employ washers.
Read more
HONDA VFR750F OWNER’S MANUAL
Your new Honda VFR750F motorcycle presents you with an invitation to adventure and a challenge to master the machine. Your safety depends not only on your own alertness and familiarity with the motorcycle, but also the motorcycle’s mechanical condition. A pre-ride inspection before every outing and regular maintenance are essential. To help meet the challenges safely and enjoy the adventure fully, become thoroughly familiar with this Owner’s Manual BEFORE YOU RIDE THE MOTORCYCLE.
Read more
HONDA CT110 Series Owners Manual
THIS IS A OWNERS MANUAL FOR A HONDA CT110 SERIES MOTORCYCLE. PLEASE BE ADVISED THAT THIS IS THE CLOSEST THING TO THE HARDKNOCK BOBBER. WE ARE NOT RESPONSIBLE FOR ANY INACCURACIES IN THIS MANUAL NOR MISUSE OR NON MAINTENANCE DONE ON YOUR BIKE. PLEASE READ WITH CARE AND USE COMMON SENSE. THANKS AND ENJOY YOUR HARDKNOCK BOBBER.
Engine Oil Level Check
Check the engine oil level each day before riding the motorcycle. The level must be maintained between the upper (2) and lower (3) marks on the dipstick (1).
1. Start the engine and let it idle for a few minutes.
2. Stop the engine and hold the motorcycle in an upright position on firm, level ground.
Read more
KIM01 K20A/A2/A3/Z1 Throttle Body To RBC/RRB/RBB Intake Manifold Adapter Installation
This adapter provides the SOLUTION for directly bolting up a 02-06 RSX-S/ITR or 02-05 Civic Si/CTR Throttle Body to an Accord Euro R, 06-08 Civic Si, or 04-05 TSX Intake Manifold.
Ease of fitment has been confirmed for the following vehicle/engine/mount combinations:
-1992-1995 Honda Civics equipped with a K20 engine and Hasport EGK1 engine mounts
-1996-2000 Honda Civics equipped with a K20/24 engine and Hasport EKK2 engine mounts
-1994-2001 Acura Integras equipped with a K20 engine and Hasport EGK1 engine mounts
-2002-2006 Acura RSX-S/Honda ITRs with a K20 engine and all available engine mounts
Read more
2002 Honda RSX - Intake Manifold Removal and Installation
Exploded View - K20A3 Engine Removal - K20A3 Engine
1. Remove the intake manifold cover.
2. Disconnect the intake air temperature (IAT) sensor connector (A), and remove the breather hose (B), then remove the air cleaner housing (C).
3. Remove the throttle cover (A). Fully open the throttle link and cruise control link by hand, then remove the throttle cable (B) and cruise control actuator cable (C) from the links. Loosen the locknuts (D), and remove the cables from the bracket.
Read more
Service Bulletin 2005 American Honda Motor Manual
This service bulletin applies to all Acura vehicles. covered by the New Vehicle Limited Warranty ….. the appropriate service manual, service bulletins, or
Read more
