2003–2008 Toyota Corolla Matrix Front Brake Rattle Noise
The information contained in this TSB supersedes TSB No. BR004-07. • The Title has been changed from “Front Brake Squeak” to “Front Brake Rattle Noise”. • Applicability has been updated to include 2008 model year Corolla and Matrix vehicles. • Production Change Information has been updated with new VIN information. • Parts Information has been updated. • The Components illustration (Figure 1) has been updated. • Step 1 in the Repair Procedure has been modified. TSB No. BR004-07 is Obsolete and any printed versions should be discarded. Be sure to review the entire content of this service bulletin before proceeding. Introduction Some customers may experience a front brake rattle type noise when the car is traveling over bumps. Updated front disc brake cylinder (caliper) mountings and disc brake pad support plates are available to eliminate this condition.
Repair Procedure
1. Conduct a road test to verify the noise condition — front brake rattle noise will occur when the front tire runs over a depression in the road. 2. Remove and replace the front disc brake pad support plates (2 per each caliper).
NOTE The procedures listed below are for one side and should be used for both the RH and LH side. A. Remove the front wheel. B. Remove the caliper by holding the front disc brake slide pin and removing the 2 bolts. C. Remove the 2 front brake pads from the front disc brake cylinder mounting. D. Remove the anti-squeal shims and the pad wear indicator plates from each pad. E. Remove the 2 front disc brake pad support plates from the cylinder mounting. F. Remove the front disc brake cylinder mounting by removing the 2 bolts. G. Install the NEW disc brake cylinder mounting with the 2 bolts. Torque: 107 N*m (1089 kgf*cm, 79 ft*lbf) H. Install the 2 NEW disc brake pad support plates. Apply disc brake grease to the back of the brake pad support plate.
Download pdf 2003–2008 Toyota Corolla Matrix Front Brake Rattle Noise
Related Searches:
Comments
Leave a Reply
